Nozzle Brass, 0.4mm, E3D "Volcano"

$9.00
In stock
SKU
3DS_E3D_VNOZZ_BRS_04
This is the default JellyBOX nozzle. It's reasonably fast, and retains good amount of detail. Nozzles with 0.4mm orifice are the de-facto default in all FFF 3D printing. Brass has low friction and good thermal conductivity, making it a great nozzle material. However, brass is quite soft and wears out, so you need to replace your nozzle every few months to maintain peak performance. Thankfully, these are relatively cheap.

JellyBOX Universal Hot End is compatible with both JellyBOX 2 and JellyBOX Original (JellyBOX 1). Each hot-end is professionally assembled by our workers, properly heat-tightened and tested for leaks.

It's made from high quality components:

  • original E3D heat sink
  • original E3D brass nozzle 0.4mm
  • IMADE3D designed long melt zone (20mm)
  • high-performance US-made Capricorn XS Deep Blue PTFE
  • NTC thermistor insulated with a US-made fiberglass sleeve
Write Your Own Review
You're reviewing:Nozzle Brass, 0.4mm, E3D "Volcano"
© 2017 IMADE3D Shop. All Rights Reserved.